Installation instructions to make your HotSeat Chassis completely portable.

1. Locate the two (2) wheels, with the Split collars attached and the 2 1/8” ABS, which has been packed in a separate box in the main shipment.
2. With the Allen Wrench provided, remove half of the split collar and the ABS (NOTE: DO NOT DISCARD THE ABS, AS IT WILL BE USED FOR LEVELLING THE CHASSIS)
3. Place the Wheel with the split collar on the inside front corner of the chassis, in front of the speakers.   Place the other half of the split collar around the frame and tighten with the hex screws.
4. At the rear of the chassis, remove the end caps on the bottom of the frame and insert the 2 1/8” ABS for leveling.
5. To move chassis in to desired location, make certain pins are securely fastened, holding chair in place.  Lift from the holes in the back of the seat and wheel chassis, with ease.

Your HotSeat Chassis is now completely portable for any event.